Fluidsim examples
Step 5: Creating the secondary control circuit. But, first, double click the 3/2 way DCV so that a dialog box will appear.Ĭonfigure all exhaust terminal as designated to terminal no. Follow the steps as indicated in the figure below. Do this step for all equipment, as shown in figure.Ĭonfiguring the 3/2 way DCV. Click first the terminal designation, hold then drag to the next terminal. Double click the 5/2 way DCV first before a dialog box appears.Ĭonnecting the 5/2 way DCV to the 3/2 way DCV. Follow the procedure as indicated in the figure below.
![fluidsim examples fluidsim examples](https://d3i71xaburhd42.cloudfront.net/352aad9d5b3b1bb8e72082fdd4b64652a985d00a/2-Figure4-1.png)
To finish the configuration of the 5/2 way DCV, put the terminal designation number for the pneumatic actuation of the 5.2 way DCV. The result will look the same with the figure below. Step 4: Configure and connect equipment Configuring the 5/2 way directional control valve, simply follow the steps as indicated in the figure.Īfter following the procedure as indicated in the figure above. And, arrange the materials according to the picture shown below. After clicking the material, you simply drag it to the new project workplace.ĭo it until you selected all the necessary listed materials. Step 3: Select the Materials to be used To select the materials to be used, you click the symbol of material as indicated in the left pane in the worksheet.
![fluidsim examples fluidsim examples](https://i.ytimg.com/vi/WQkUou6c-64/maxresdefault.jpg)
Select NEW or you can directly use shortcut key CRTL + N. Step 2: Create a NEW Project Locate FILE on the menu bar, and a drop-down option appears.
![fluidsim examples fluidsim examples](https://i1.rgstatic.net/publication/321109805_Simulation_and_modeling_of_a_hydraulic_system_in_FluidSim/links/603df3c9a6fdcc9c78082ea2/largepreview.png)
So, both cylinder will not retract at the same time, but the double-acting cylinder #2 will be depend on the position of double-acting cylinder #1, either at 0 mm or at 100 mm (full retraction). Our desired output will be an automatic sequential/ alternating retraction of piston in two pneumatic double-acting cylinder.
#FLUIDSIM EXAMPLES SOFTWARE#
Let’s start with the materials and software that we will be using in this topic.ģ/2 way directional control valve, normally close push button, spring-returnedģ/2 way directional control valve, normally open limit switch, with roller, spring-returnedĥ/2 way directional control valve, pneumatically actuated.